SmartBee Controllers Accessories

Provides both an Audible (93db) and Visual (non-flashing) alarm that can be used for a “High” and “Low” Temperature, Humidity or CO2 setting. Alarm will trigger if either level is hit. Alarm will remain active as long as target parameter is out of the desired range. Audible alarm can be silenced either by pushing a re-set switch on unit or setting an alarm duration (adjustable over a short range). The Visual alarm indication will remain on as long as the alarm condition exists. Used in conjunction with a SmartBee SS4.
Note: BOTH trigger cables must be plugged into the same SS4 to avoid safety related issues.

The SmartBee range extender boosts your Garden Network signal to enable extending the physical area that your system can cover, by acting like a repeater. Used in cases when either sensor or control devices have a consistently poor RSSI reading because the devices are spread out over to large an area. R when used in conjunction with a Thru-Wall kit enable network communications through a non-conducting wall or partition.

The Stinger Smart Contactor (SSC) is designed to extend the capabilities of the SmartBee SS4 by providing 20A capability to a port on your SS4. Plug the trigger cable into a port on your SS4 and your higher power device into the 5-20P receptacle, then plug the 5-20P power input cable into a standard 20A receptacle.

The Stinger Smart Contactor (SSC) is designed to extend the capabilities of the SmartBee DCC8 by providing 20A capability to a port on your DCC8. Plug the trigger cable into a port on your DCC8 and your higher power device into the 5-20P receptacle, then plug the 5-20P power input cable into a standard 20A receptacle.